DIN rear mount installation
(uses factory radio mounting bracket)
Select a position on the head unit
housing where the screw holes of the
factory radio bracket align with the
threaded screw holes on sides of the
head unit (Figure 3).
select two mounting hole positions on
each side of head unit
Figure 3. Select mounting holes
Insert screws in two such locations
on each side, and tighten securely
(Figure
4).
NOTE: For the rear-mount
installation, do not use the trim piece,
backstrap or mounting case.
factory mounting
bracket
factory bezel or
dashboard opening
Rgure 4. Insert screws and tighten
Removing the head unit
Should you need to remove the head
unit, insert the levers supplied with
the head unit into the slots near the
left and right ends of the faceplate as
shown in the drawing until you feel a
"click." You can now use the levers
to pull the unit from the dashboard
(Figure 5).
Figure 5 Insert levers until "click" occurs, then use
levels to pull out head unit.
75001 User's Manual - page 3