Dr Screening Table For Olg - Toshiba Strata CTX Programming Manual

Services
Least Cost Routing/Destination Restriction
F
IELD
04 Digit Modification
Action
05 Skip Length

531 DR Screening Table for OLG

Prerequisite Program:
Assigns DR Screening Table for an OLG. Up to four codes may be assigned per line group. Used for
outgoing calls other than LCR.
F
IELD
00 Outgoing Line Group
01 Behind Centrex Access
Code
02 Add or Delete Code
03 DR Action for Centrex
04 Skip Length
05 Pause Length
9-20
D
ESCRIPTION
Select Digit Modification application.
Possible values:
Apply – (default) Apply Digit Modification from the first digit.
•
Retain – Retain the skipped digits and apply Digit Modification starting from
•
the next digit specified by Skip Length.
Discard – Discard the skipped digits and apply Digit Modification starting
•
from the next digit specified by Skip Length.
Specify the number of digits at the beginning of the dial string to be ignored
before DR, Digit Modification, or LCR is applied.
Possible values: 0~5, 0 = delete (default = 0)
None
D
ESCRIPTION
Enter the OLG Number.
Possible values: 1~32 (CTX100), 1~50 (CTX670 Basic),
1~128 (CTX670 Exp.), (default = no value)
Enter the access code expected by an attached Centrex PBX.
Possible values: Up to 8 ASCII characters (default = no value)
Add or Delete the Code entered above. Leaving the field empty removes an
existing code. Activation requires entries in OLG Group number and 01 Behind
Centrex Access Code above.
Possible values: Add or Delete (default)
Apply DR to the dialed digits.
Possible values:
Bypass (default) – does not apply DR.
•
Skip and Apply– applies DR to the dialed digits excluding the number of
•
digits specified in Skip Length.
Enter the number of leading digits to be ignored by DR.
Possible values: 0~8 (default = 0)
Enter the length of the pause to be inserted between dialing digits.
Possible values: 0~10 (default = 0)
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03