Lcr Exchange Line Programming Reference Table - Toshiba Strata DK40 Programming Manual

LCR Exchange Line Programming Reference Table

1. Use
Line Group
01
02
03
04
05
06
07
08
2. Use
3. Use
4. Use
calls will originate.
5. Under the column labelled "Exchange Line Type/ Comments," enter the service type,
the common carrier name, or the line type for each line group, e.g., local line, ISDN30,
ISDN2 (TE), etc.
6. Refer to the Program 40
including using LCR. All stations that must use LCR to make outgoing calls must not be
restricted in this program. These restrictions do apply to LCR.
7. Refer to Program
LCR. All stations that must use LCR for outgoing calls must be restricted from line
access in this program.
Strata DK40 Programming Manual Spring 1999
Program 16 to assign Exchange lines in groups per the reference table below.
Processor
DK40
Exchange Line in Group
Program 40 to allow Exchange line access to stations using LCR for outgoing calls.
Program 41 to deny outgoing Exchange line access, except for LCR access.
Program 45-1 to enable the dial plan that is appropriate for the area where the LCR
to restrict stations from incoming and outgoing access of lines,
41, to restrict stations from accessing outgoing lines, except through
Exchange Line Group
1~8
Exchange Line Type/Comments
Least Cost Routing
5-3