Memory Monitoring Settings - D-Link DFL-1660 User Manual

2.4.4. Memory Monitoring Settings

displayed next to the sensor in the output from the hwm command.
Controlling the Event Sending Frequency
The maximum frequency of log event generation when hardware monitoring values fall outside their
preset range can be limited using the AlarmRepeatInterval setting in the LogSettings object. This
setting is used because the monitored values are continuous.
For example, to change the interval from the default of 60 seconds to a new value of 900 seconds,
use the CLI command:
gw-world:/> set Settings LogSettings AlarmRepeatInterval=900
This means that a new event message must now wait for 900 seconds after the previous one has
been sent.
All the options for LogSettings can be found in Section 2.2.8, "Advanced Log Settings".
2.4.4. Memory Monitoring Settings
The System > Hardware Monitoring section of the Web Interface provides the administrator with
a number of settings related to the monitoring of available memory. These are:
Memory Poll Interval
Memory polling interval which is the delay in minutes between readings of memory values.
Minimum 1, Maximum 200.
Default: 15 minutes
Memory Use Percentage
True if the memory monitor uses a percentage as the unit for monitoring, False if megabytes are
used. Applies to Alert Level, Critical Level and Warning Level.
Default: True
Memory Log Repetition
Should we send a log message for each poll result that is in the Alert, Critical or Warning level, or
should we only send when a new level is reached. If True, a message is sent each time Memory Poll
Interval is triggered. If False, a message is sent when a value goes from one level to another.
Default: False
Alert Level
Generate an Alert log message if free memory is below this number of bytes. Disable by setting to 0.
Maximum value is 10,000.
Default: 0
Critical Level
Chapter 2. Management and Maintenance
79