Table of Contents
Advertisement
Continued From Previous Page
To mount the I.R.E.D. follow these steps:
1)Before drilling any holes be sure to test the I.R.E.D. in the location you desire to
mount it in by either holding the I.R.E.D. in place or use double sided tape to hold it
into position.
2)If the SWC-01 works properly you can now mount the I.R.E.D. If possible remove the
panel from the vehicle and drill a 5/16th inch hole. If the panel cannot be removed be
sure to check clearance behind the panel so not to damage any wiring with the drill bit.
3)Take the I.R.E.D. and place the snap in mount over it. Feed the cable through the
mounting hole and snap the I.R.E.D. into the hole.
4)Run the I.R.E.D. cable up to the SWC-01 and connect it. Tie up any loose wiring to
prevent it from getting it caught on any moving parts.
Final Testing
Once all connections have been made, turn the radio on and adjust the steering wheel
volume controls up and down. If the volume controls do not work:
1)Check to see if there is 12 volts on the red wire and the black wire is connected to a
good ground.
2)Make sure the correct steering wheel control wire is used, green for resistive type
steering wheel controls and pink for data type steering wheel controls.
3)Make sure the Dip switch settings are set correctly for your radio and vehicle.
SWC-01
16
Hide quick links:
Advertisement
Table of Contents
