Advertisement
Programming the ASWC-1:
1. Press and hold the "Volume-Up" button on the steering wheel, then turn the ignition on.
The L.E.D. will start flashing rapidly, which means the ASWC-1 is looking for the vehicle
and the radio.
Note: If the L.E.D. didn't start flashing rapidly, press the reset button for 3 seconds, while still
holding the "Volume-Up" button.
2. After a few seconds the L.E.D. should stop flashing rapidly, then go out for approximately
2 seconds.
3. After approximately 2 seconds there will be a series of 7 Green flashes, some short, and
some long. The long flashes represent the wires that are connected to the ASWC-1.
Tip: Knowing this will help to troubleshoot, if need be.
4. The L.E.D. will pause for another 2 seconds, then flash Red up to 18 times depending on
which radio is connected to the ASWC-1. Refer to the L.E.D. feedback section for information.
5. This is the end of the auto detection stage. If the ASWC-1 detected the vehicle and the radio
successfully, the L.E.D. will light up solid. Release from holding the "Volume-Up" button.
6. Test the steering wheel controls for proper operation. Refer to "(ASWC-1) Steering wheel
control settings" for customizing the buttons, if so desired.
PROGRAMMING THE ASWC-1 AND CLIMATE DISPLAY
Programming the climate display:
7. Turn the parking lights on.
8. Turn the vehicles light dimmer all the way down, then all the way up.
9. Turn the lights off.
10. Test all functions of the installation for proper operation, before reassembling the dash.
FINAL ASSEMBLY
1. Secure the climate control assembly to the dash in reverse order of disassembly using the
factory screws.
2. Secure the radio assembly to the dash using the factory screws.
3. Reassemble the dash in reverse order of disassembly to complete the installation.
11
REV. 12/4/2019 INST99-7389B
Advertisement
