Checking The Sewing Pattern In Test Mode - Brother RH-9820 Instruction Manual

5-4. Checking the sewing pattern in test mode

Test mode can be used to make only the feed base move in the same way as during normal sewing, but with the upper shaft stopped. This
mode is useful for checking the positions of the needle and other parts and of the other parts relative to each other.
1
Switch the mode to test mode.
0410B
2
Select the desired program number (2).
0413B
3
Press the work clamp switch (5).
0419B
4
Press the start switch (6).
0420B
5
Press the start switch (6) or the
(The feed base will move forward by 2 stitches each time the
switch or key is pressed.)
(The feed base will move quicker if you keep the switch or key
pressed down.)
0421B
5. USING THE SEWING MACHINE (OPERATION PANEL: BASIC OPERATION)
(1)
The sewing shape (1), program number (2), total number of stitches (3) and number
of remaining stitches (4) will appear in the display.
The program No. (2) changes in the order shown in the illustration each time the
key is pressed. (The
The work clamps will be lowered.
The feed base will move to the sewing start position.
switch to start test feeding.
RH-9820
(2)
(4) (3)
Independent program
(Refer to P. 39)
key changes the order in the opposite direction.)
The number of remaining stitches (4) on the display
will decrease by 2 each time.
When the final stitch is reached, the buzzer will
sound.
Thread trimming and cutting operation will not be
carried out in test mode.
0230B
Cycle program
(Refer to P. 57)
(2)
0337B 0230B
0231B
(4)
(Continued on next page)
46