Checking The Sewing Pattern - Brother BAS H Series Instruction Manual

1. USING THE LCD PANEL (BASIC OPERATIONS)

1-4. Checking the sewing pattern

Use test feed mode to operate the feed mechanism in order to check the needle movement.
Check that the needle hole does not come out from the frame of the work clamp.
1
The Test key is displayed in blue.
[Sewing operation screen]
(1)
2
Continuous test feed
2nd step
Work clamp switch (2-step)
14
Start switch
Left switch
(5)
1. Touch the Test key at the sewing operation
screen.
2. Press the △ or ▽ key (1) to set the program
number that you would like to check.
1. Depress the foot switch to the 2nd step (for a
2-pedal foot switch, lower the work clamp and
then depress the start switch. For the hand
start switch, press the right switch to lower the
feed plate lock cylinder and work clamp, and
then press the left and right switches at the
same time.) Furthermore, if you touch the
continuous feed key (2), the feed mechanism
will start moving continuously one stitch at a
time.
(The current stitch number in the stitch number
display will increase by 1 each time.)
2. When the feed reaches the end of the pattern,
it stops.
・ If you would like to stop the feeding operation,
touch the continuous feed stop key (3).
Right switch
・ If you touch the continuous feed key (4), the
feed mechanism will start moving continuously
in the direction of the sewing start position one
stitch at a time.
・ Touch the Move to sewing start key (5) to
return to the sewing start.
BAS H series
4441Q
4923Q
4169B