Installing And Removing The Work Clamp Plates - Brother RH-9820 Instruction Manual

3. INSTALLATION

3-19. Installing and removing the work clamp plates

<Removal>
3. Push the left and right plate pressers (3) in the directions of the arrows (toward the outside).
4. While holding the clamp lever (5), insert a finger into the notch (6) and push up the right work clamp plate (4) to remove it
from the pin (7).
5. Pull the right work clamp plate (4) forward to remove it.
NOTE:
Move the feed base (2) to a position where the work clamp plate JU (8) can be removed without touching the needle,
and then lift up the right work clamp plate (4) and remove it.
6. Remove the left work clamp plate (9) in the same way as for the right work clamp plate (4).
<Installation>
Install by carrying out the "Removal" procedure given above in reverse.
27
1. Turn the upper shaft pulley (1) forward to align the mating
0386B
mark (A) on the pulley with the notch (B) in the machine
head.
* The needle will be set to the needle up stop position.
2. Move the feed base (2) forward.
RH-9820
0387B