Adjusting The Positions Of The Work Clamp Plates - Brother RH-9820 Instruction Manual

9. STANDARD ADJUSTMENTS

9-20. Adjusting the positions of the work clamp plates

Adjust the positions of the work clamp plates (3) so that the throat plate (1) and needle plates (2) do not touch during sewing.
The standard adjustment is when there is a gap of 0.8 mm between the throat plate (1) and the needle plates (2) (when the
cutting space is set to "0").
* Carry out adjustment for both the left and right work clamps. (The adjustment method described below is for the position of
the right-side work clamp plate (3).)
* Carry out adjustment with the work clamp plates (3) installed.
4. Check that there is a gap of 0.8 mm between the throat plate (1) and needle plate R (2).
5. If there is not a gap of 0.8 mm, loosen the nut (8), and then turn the bolt (9) to adjust.
6. Once adjustment is complete, tighten the nut (8).
7. Press the STOP switch (10), and then press the RESET key (11) to end test mode.
* Adjust the gap between the throat plate (1) and needle plate L in the same way.
93
(when using a 2-pedal
foot switch)
(Seen from the front)
1. Use the parameter settings to set the cutting space to "0".
0512B
(Refer to "5-3. Program setting method".)
* If you press shortcut key 3 (4), you can then change
the value simply by pressing the
2. Press the TEST key (6) to turn on test mode, and then
start test operation. (Refer to "5-4. Checking the sewing
pattern in test mode".)
3. Press and hold the start switch (7) until the feed base
moves to the position where the straight section of the
sewing shape is sewn, and then release the start switch
(7).
0462B
Narrow gap
Wide gap
RH-9820
/
Straight section
(Seen from directly above)
keys (5)
0513B
0514B