When Embedding Into The Table - Brother RH-9820 Instruction Manual

3-1-2. When embedding into the table

When embedding the machine head into the table, some extra components will be required, so contact the place of purchase
for further details.
NOTE:
When embedding the machine head into the table, be sure to install the L-shaped table reinforcement plates. (Refer to "3-3.
Installing the table reinforcement plates (embedded installation only)".)
4 x 4 mm dia.
20 depth
(From underneath
table)
For valve unit
For cotton stand
For table leg
For bed support plate
For pneumatic unit
Shaded area should
be C10
If the table is more than 50 mm thick, the square neck bolts
will not be long enough, so hollow out the underside of the
table to a diameter of 26 mm so that the thickness is 40
mm.
RH-9820
For L-shaped reinforcement plates
For operation panel
4 x 2 mm dia. 10 depth
2x 2mm dia. 10 depth
(from underneath
table)
For power switch
3. INSTALLATION
For operation panel cord
For control box
Melamine veneer panel
1595B
1594B
6