Checking The Sewing Pattern - Brother BAS H series Instruction Manual

1-4. Checking the sewing pattern

Use test feed mode to operate the feed mechanism in order to check the needle movement.
Check that the needle hole does not come out from the frame of the work clamp.
1
The Test key is displayed in blue.
[Sewing operation screen]
(1)
2
Continuous test feed
2nd step
Work clamp switch (2-step)
Single stitch check
Start switch
(2)
BAS H series
1. USING THE LCD PANEL (BASIC OPERATIONS)
1. Touch the Test key at the [sewing operation
screen].
2. Press the △ or ▽ key (1) to set the program
number that you would like to check.
1. If depress the foot switch to the 2nd step, the
feed mechanism starts moving continuously
one stitch at a time.
(If using a two-pedal foot switch, lower the
work clamp before depressing the start switch.)
2. When the feed reaches the end of the pattern,
it stops.
・ If you would like to stop the feeding operation,
touch the Continuous feed stop key.
・ Touch the Move to sewing start key (2) to
return to the sewing start.
Touch to move back by one stitch.
Touch to move forward by one stitch.
Fast-forward
4441Q
4923Q
10