CYBEX Eagle Hip Abduction/Adduction Owner's Manual page 20

B. Install the top two screws securing the back shroud.
See Figure 10.
C. Route weight stack belt through the slot in the back
shroud (moving from bottom to top).
D. Properly route belt around upper pulley and down
to weight stack.
E. Install the three Phillips head screws securing the
top (back) shroud. See Figure 11.
F. Carefully lift top weight and verify that the position of the
belt clamp (on the top weight) is aligned properly with the
top pulley bracket (on the machine). See Figure 12.
G. Slide belt through slot in belt clamp.
H. Verify belt and insert are installed properly, as shown
in Figure 13A. NOTE: Do not install the insert backwards
as shown in Figure 13B.
I. Pull belt tight and secure belt to clamp with the two
set screws. NOTE: Torque set screws 300-350 in./lbs.
See Figure 14.
J. Place weight stack pin in each plate to verify proper
installation.
K. Without selecting any resistance, lift top weight up
and down (simulating normal operation).
L. Have an assistant verify that the belt is moving
smoothly and is routed straight from the top pulley
bracket to the top weight belt clamp.
Assembly
Page 4-4
Cybex Eagle 11181 Hip Abduction/Adduction Owner's Manual
Figure 10
Figure 11
Top Pulley
Belt
Increment
Weight
Adjusting
Knob
Figure 12 (top view from pulley down to belt clamp)
Correct belt routing
Insert
Belt
Stem
Figure 13A
Belt
Set screws
Figure 14
Screw
Phillips Head
Screw (3)
Insert and Set
Screws (not
shown) are on
this side.
Wrong belt routing
Insert
Belt
Stem
Figure 13B
Belt clamp
insert
Belt clamp