Assembly - CYBEX Eagle Hip Abduction/Adduction Owner's Manual

TOOLS REQUIRED
• 7/32" Allen wrench
• 3/4" Allen wrench
• 9/16" Wrench
• 3/4" Socket or wrench
• External snap ring pliers
• Phillips screwdriver
• Medium weight automotive engine oil
• Torque Wrench
NOTE: Two people will be required for this procedure.
NOTE: It is the responsibility of the facility owner/owner of the
equipment to ensure that there is appropriate
clearance around each machine to allow for safe use and passage.
1. Read and understand all instructions thoroughly before starting any of the procedures
listed on this instruction sheet.
2. Verify you have received the appropriate confi guration.
A. Verify that you received the correct color machine that you ordered.
B. Verify you received weight plates and weight plate decals.
C. Verify you received the Cybex Eagle Hip Abduction/Adduction Owner's Manual.
D. Verify you received the warranty sheet.
3. Move to desired location.
A. Note the diminsions of the machine:
idle - 67 L x 35 W x 57 H inches
170.18 L x 88.9 W x 144.78 H cm
in use - 81 L x 68 W x 57 H inches
205.74 L x 172.72 W x 144.78 H cm
Machine Weight (with weight stack) - 650 lbs. (294.83 kg)
B. Determine if you can move your machine through the required doorway(s).
C. If the machine fi ts through the doorway(s), move machine to desired location and skip to step 5.
D. If weight stacks need to be installed proceed to step 6.
E. If the machine does not fi t through the door-way(s) then see step 4.
4. Doorway Instructions.
NOTE: If your machine fi ts through the doorway then skip step 4.
If your machine does not fi t through the doorway then perform step 4.
A. Carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench.
Cybex Eagle 11181 Hip Abduction/Adduction Owner's Manual

4 - Assembly

ITEM QTY PART NO.
1 4 11090-392
2 1 12000-560
3 9 4000C101
30
13.5
50
22.5
70
31.5
90
40.5
110 49.5
130 58.5
150 67.5
170 76.5
190 85.5
210
94.5
230
103.5
250
112.5
270
121.5
290
130.5
DESCRIPTION
FOOT PAD
DECAL, WEIGHT PLATE (30 - 290)
WEIGHT STACK PLATE
Assembly
Page 4-1