CYBEX Eagle Hip Abduction/Adduction Owner's Manual page 18

B. Disconnect weight stack belt (by loosening the two set
screws on the belt clamp with a 7/32" Allen wrench).
See Figure 1.
C. With an assistant, carefully remove the four BHSCS
securing the two halves of the frame. See Figure 2.
D. Carefully move each half through the door-way to the
desired location.
E. With an assistant, carefully attach each half together
using the four BHSCS removed in step 4C. See Figure 2.
F. Continue on with step 5B.
5. Remove shipping feet and remove the back shrouds.
A. Carefully remove each (standard) cone-shaped
shipping support) using a 3/4" socket or wrench).
B. Carefully place rubber feet (supplied with machine)
on each foot of the frame.
C. Cut shipping tie securing top weight.
D. Lift top weight and turn the Increment Weight Adjusting
Knob to select all 15 lbs. (three increment weights each
side).
E. Remove the three Phillips head screws securing the
top (back) shroud and carefully remove the shroud.
See Figure 3.
F. Loosen bottom two screws shown in Figure 4.
NOTE: Do not remove the bottom two screws.
G. Remove the top two screws securing the back
shroud. See Figure 5.
H. Carefully slide rear shroud assembly upward and
remove.
6. Install the weight stack.
A. Note how the increment weights are installed.
B. With an assistant holding the increment weights, move
the adjusting knob to 0 lbs. and remove all six increment
weights (three each side).
Assembly
Page 4-2
Cybex Eagle 11181 Hip Abduction/Adduction Owner's Manual
set screws (2)
Figure 1
BHSCS (qty 2)
Nylon Locknut (2)
BHSCS (qty 2)
Figure 2
Figure 3
Figure 5
Nylon Locknut (2)
Phillips Head
Screw (3)
Screw (loosen -
do not remove)
Figure 4
Screw