Remote Operations; Installing The Batteries - JVC KD-SX1000R Instructions Manual

REMOTE OPERATIONS

Before using the remote controller:
• Aim the remote controller directly at the remote sensor
on the main unit. Make sure there is no obstacle in
between.
• Do not expose the remote sensor to strong light (direct
sunlight or artificial lighting).

Installing the batteries

When it becomes necessary to bring the remote controller close to the remote sensor for it to
work, the battery is running low, at this point, the battery should be replaced. (Battery life is
about 1 year with normal use.)
(back side)
1)
Lithium coin battery
(product number:
CR2025)
(back side)
WARNING:
• Store the batteries in a place which children cannot reach.
If a child somehow ingests the battery, immediately consult a doctor.
• Do not recharge, short, disassemble or heat the batteries or put them in a flame.
Doing any of these things may cause the batteries to give off heat, crack or start a fire.
• Do not mix the batteries with other metals.
Doing this may cause the batteries to give off heat, crack or start a fire.
• When throwing away or saving the batteries, wrap in tape and insulate.
If this is not done, it may cause the batteries to give off heat, crack or start a fire.
• Do not poke the batteries with a metal pin set of similar device.
Doing this may cause the batteries to give off heat, crack or start a fire.
38
1. Remove the battery case.
2)
2. Replace the battery.
3. Return the battery case.
1) Push in the direction indicated by the arrow with
your right hand thumbnail.
2) Remove the battery case.
Put the battery in the case with the + side facing
upwards.
Insert again the battery case pushing until you hear a
clicking sound.
Remote sensor