Xerox 4635 User Interface Reference page 147

XEROX 4635 LASER PRINTING SYSTEM PC USER INTERFACE REFERENCE
STOP if Sequence Error - Selection of this check box causes
the following window to appear when a sequence error
occurs. This is a secondary safeguard in case the IOT does
not detect a sequence error or the operator has set the 'NO
SEQ' command. This will also occur in BAR ALI mode.
Sequence errors are detected as soon as the controller
reports the sheet delivery of the page out of sequence.
STOP command will be issued to the printer if selected. The
printer will finish all of the pages in progress and then stop.
The system is locked up until a selection is made and the
Apply/Close header button is selected. If display is selected
the user will have to close the display select one of the
ignore options to continue.
Sequence error is the error that occurs when the actual
barcode scanned does not match the next number in the
sequence. Refer to the Xerox 4635 LPS PDL/DJDE Reference
manual for more information on how to define sequence
data.
Figure 8-33. Audit Log Sequence Error window
• Ignore the error - This will Ignore the error on this report
only. A CONTINUE command will be sent to the printer.
• Ignore the error for the rest of the job - This will ignore the
error on this report and all other reports in this job. A
CONTINUE command will be sent to the printer.
• Display the Log - The Audit Log Display window will appear
and the log with the error will be displayed. After closing the
Audit Log Display window this window will appear again to
enable selecting the desired action.
Audit Report: - These selections set up the defaults for the
display and printing functions of the Audit Log. Except for the
'Detail Log', 'Show Purge/Jam', and the 'Show Operations'
(which will set in the BTEXT command) these are used as default
SYSTEM CONTROL WINDOWS
A
8-35