D-Link DCS-2000 Manual page 23

Configuration > Advanced > Network Settings
Any changes made to these settings will require the system to
restart to validate. Make sure every field is correctly typed before
clicking on:
Reset IP address at next boot
The box is checked when first installed.To avoid performing a software installation
whenever the DCS-2000 starts, and once the network settings, especially the IP
address, are correct, uncheck this box. This option can also be disabled using the IP
Installer program. Once the option is disabled, the DCS-2000 will skip installation at
the next boot and the IP Installer program will no longer find the installed units if any
changes are necessary to the network settings. It may be necessary in that case to
to recover the DCS-2000 by restoring factory default settings. However, with this
option disabled the DCS-2000 can automatically operate normally after restarting in
case of losing power.
General
IP address -
Subnet mask -
Default router -
Primary DNS -
Secondary DNS -
SMTP
SMTP(mail) server 1 -
Recipient email address 1 -
SMTP(mail) server 2 -
Recipient email address 2 -
Return email address
Necessary for network identification.
Used to determine if the destination is in the same
subnet. The default value is "255.255.255.0".
The gateway used to forward frames to destinations
in a different subnet. Invalid router setting will fail in
transmission to destinations in different subnet.
Primary domain name server who translates names
to IP addresses.
Secondary domain name server to backup the
primary one.
The domain name or IP address of external email
server.
The email address of recipients for snapshots or log
file. Multiple recipients must be separated by
semicolon, ';'.
The domain name or IP address of another email
server once the previous server is unreachable.
the email address of recipients for the backup server.
The return email address once the mails fail to send
out.
Continued on Next Page
23