D-Link DCS-2000 Manual page 11

The opening Installer screen will appear.
IMPORTANT:
A hardware reset of the Internet Camera is now necessary to allow the Installer
program to configure the camera correctly. To accomplish this reset, lightly
insert a paper clip into the reset hole on the back of the camera (see page7 for
the location of the reset hole.) The LED on the front of the camera will begin
blinking red and green. When it stops the blinking cycle continue to hold in the
reset button until a second cycle of blinking red and green lights indicates a
second reset cyle has completed. This will take approximately 5-7 seconds.
The installer will now show a MAC address for the DCS-2000 and an IP address.
This IP address may not be correct at this step in the installlation.
Highlight the MAC address and then click on the Wizard button to activate the
installation Wizard.
Press Next on the Welcome screen to continue the Wizard.
Click Next
11