Honda Civic Service Manual page 1130

)
)
Side lmpact Sensor Replacement
Removal
1. Disconnect the battery negative cable, and wait at
least 3 minutes before beginning work.
2. Disconnect the appropriate side airbag 2P
connector (see step 4 on page 23-21).
3. Remove the seat assembly (see pa ge 20-71J.
4 . R e m o v e t h e f r o n t d o o r s i l l t r i m a n d t h e B - p i l l a r
lower trim panel (see page 20-50).
5. Disconnect the floor wire harness 2P connector
from the side impact sensor.
6. Remove the Torx bolt (A) using a Torx T30 bit, then
remove the side impact sensor (B).
)
lnstallation
1 . I n s t a l l t h e n e w s i d e i m p a c t s e n s o r w i t h a n e w T o r x
bolt (A), then connect the floor wire harness 2P
connector {B) to the side impact sensor {C).
2.
3 .
Reconnect the negative battery cable.
After installing the side impact sensor, confirm
proper system operation:Turn the ignition switch
O N ( l l ) ; t h e S R S i n d i c a t o r s h o u l d c o m e o n f o r a b o u t
6 seconds and then go off.
Install all removed parts.
23-123