Honda Civic Service Manual page 1129

sRs
SRS Unit Replacement
Removal
'1.
Disconnect the battery negative cable, and wait at
least 3 minutes before beginning work.
2. Disconnect the driver's and front passenger's
airbag connectors (see page 23-21).
3. Disconnectthe side airbag connectors (see page
23-211.
4 . Disconnect both seat belt tensioner connectors (see
page 23-22) and both seat belt buckle tensioner
connectors {see page 23-221.
Remove the dashboard center lower cover (see
step 2 on page 20-57).
Pull down the console carpet on the passenger's
side, then remove the Torx bolt (A)from the SRS
u n i t .
7. Pull down the console carpet on the driver's side,
then disconnect the connectors. Remove the Torx
bolts (A), then pull out the SRS unit.
23-122
lnstallation
1 , I n s t a l l t h e n e w S R S u n i t ( A ) w i t h T o r x b o l t s ( B ) , t h e n
connect the connectors {C) to the SRS uniu push
them into position until they clicks.
NOTE: When tightening the Torx bolts to the
specified torque, be careful to turn them in so that
their heads rest squarely on the brackets.
Reinstall the dashboard center lower cover (see
step 2 on page 20-57).
Reconnect the driver's and front passenger's airbag
connectors (see page 23-21]'.
Reconnect the side airbag connectors (see page 23-
211.
Reconnect both seat belt tensioner connectors (see
page 23-221 and both seat belt buckle tensioner
connectors (see page 23-22).
Reconnect the battery negative cable.
I n i t i a l i z e t h e O P D S u n i t ( s e e p a g e 2 3 ' 2 7 ) .
After installing the SRS unit, confirm proper system
operation: Turn the ignition switch ON (ll); the SRS
i n d i c a t o r s h o u l d c o m e o n f o r a b o u t 6 s e c o n d s a n d
then go off.
4.
6 .
8 .
7 .
9.8 N.m (1.0 kgf m, 7.2 lbf ft)