Honda Civic Service Manual page 1013

9 .
1 0 .
Remove the B-pillar upper trim {see page 20-50)
Remove the shoulder anchor adjuster{A).
22 N.m (2.2 kgf.m, 16lbf.ftl
Installthe seat belt in the reverse order of removal,
and note these items:
. lf thethreads on the retractor mounting self-
tapping ET screw are worn out, use an oversized
self-tapping ET screw (P/N 90133-SZ4-0030)
made specifically for this application.
. Check that the retractor locking mechanism
functions (see page 23-9).
. A s s e m b l e t h e w a s h e r s , c o l l a r s , a n d b u s h i n g o n
the upper and lower anchor bolts as shown.
. lf the seat belt tensioner has been deployed
replace the front seat belt protector with a new
o n e .
. A p p l y l i q u i d t h r e a d l o c k t o t h e a n c h o r b o l t s
before reinstallation.
. Before installing the anchor bolts, make sure
there are no twists or kinks in the front seat belt.
. Make sure the seat belt tensioner connector is
plugged in properly.
. Reconnect the negative cable to the battery.
. Enter the anti-theft code for the radio, then enter
the customer's radio station presets.
. Reset the clock.
. Do the ECM/PCM idle learn procedure {see page
1 1 , 1 3 9 ) .
1 1 .
8 x 1.25 mm
UPPER ANCHOR
BOLT
BUSHING
Upper anchor bolt construction:
UPPER ANCHOR
Lower anchor bolt construction:
COLLAR
TOOTHED
LOCK WASHER
LOWER ANCHOR BOLT
TOOTHED LOCK WASHER
{cont'd)
WASHER
23-5