Honda Civic Service Manual page 1072

t
I
6. Reconnect the baftery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 22-1 indicated?
YES-Go to step 9.
NO Open or increased resistance in the front
passenger's seat belt buckle tensioner; replace the
front passenger's seat belt buckle.l
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect both side airbag 2P connectors (see
step 4 on page 23-21) and the driver's seat belt
buckle tensioner 4P connector (see step 6 on page
23-22).
1 1 . D i s c o n n e c t S R S u n i t c o n n e c t o r B ( 1 8 P ) f r o m t h e
SRS unit (see step 7 on page 23-22). Do not
disconnect the special tool from the floor wire
h a r n e s s .
1 2 . C h e c k r e s i s t a n c e b e t w e e n t h e N o . 2 a n d N o . 1 1
terminals of SRS unit connector B ('l8P). There
s h o u l d b e 2 . 0 3 . 0 0 .
SRS UNIT CONNECTOR B I,I8PI
)m
3
6
7
8 9
r5 r6
1T 1 8
W i r e s i d e o f f e m a l e t e r m i n a l s
ls the resistance as specified?
YES Faulty SRS unit or poor contact at SRS unit
c o n n e c t o r B ( 1 8 P ) a n d t h e S R S u n i r . C h e c k t h e
connection; if the connection is OK, replace the
SRS unit (see page 23-122).a
NO Open or increased resistance in the floor wire
ha rness; replace the floor wire ha rness.l
I t
23-65
DTC 22-3: Short to Another Wire or
Decreased Resistance in Front Passenger's
Seat Belt Buckle Tensioner
SpecialTools Required
. SRS inflator simulator 07SAZ-TB4011A
. SRS simulator lead F 07XAZ,S230100
'1.
Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON fll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermiftent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-26),.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's seat belt buckle
tensioner 4P connector (A) from the floor wire
harness.
5 . C o n n e c t t h e S R S i n f l a t o r s i m u l a t o r ( 2 Q
connectors) and the simulator lead F to the floor
w t r e h a r n e s s .
6. Reconnect the battery negative cable.
7 . E r a s e t h e D T C m e m o r y .
{cont'd)