Honda Civic Service Manual page 1034

I
Initializing the OPDS {Occupant Position Detection System} Unit
Special Tool Required
SCS service connector 07PAz-00'1 01 00
When a seat-back cover, seat-back cushion, and/or OPDS unit is replaced, initialize the OPDS by following the
procedure below.
NOTE: Make sure the front passenger's seat is dry. Set the seat-back in the normal position, and make sure there is
nothing on the seat.
'1.
l\4ake sure the ignition switch is OFF.
2. Connect the Honda PGM Tester (A) to the DLC (16P) (B), andfollowtheTester's prompts jn the ,,SCS,, menu to
ground the SCS line (see the Honda PGM Tester Operator's ManuaD.
3. Connect the SCS service connector (C) to the MES 2P connector (D). Do not use a iumoer wire.
c
07PAZ-00r0100
4 . T u r n t h e i g n i t i o n s w i t c h O N { l l ) .
5. The SRS indicator comes on for about 6 seconds and goes off. Remove the SCS service connector from the MES
connector within 4 seconds after the SRS indicator went off.
6. The SRS indicator comes on again. Reconnect the SCS service connector to the MES connector within 4 seconds
after the SRS indicator comes on.
7. The SRS indicator goes off. Remove the SCS service connector from the MES connector withln 4 seconds.
8. Watch the sRS indicator.
' l f t h e i n d i c a t o r b l i n k s t w o t i m e s a n d t h e n s t a y s o n , t h e O P D S i s i n i t i a l i z e d . b u t t h e D T C S n e e d t o b e e r a s e d .
step 9, then erase the DTCS.
. l f t h e i n d i c a t o r b l i n k s t w o t i m e s a n d t h e n g o e s o f f , t h e O P D S u n i t i s i n i t i a l i z e d . G o t o s t e p 9 .
' lf the indicator stays on without first blinking.the OPDS is not initialized. Readthe DTC. lf DTC 15-'l is indicated,
repeat the initialization procedure. lf another DTC is indicated, go to the appropriate page in the DTC
Troubleshooting Index.
9. Turn the ignition switch off, and disconnect the PGM Tester.
SBS indic.ror
M E S
I J
DISCONNECTED
23-27