Initial Utility Installation - Planet Networking & Communication ICA-1200 User Manual

Once you have installed the IP Camera well and powered it on, the network accessing type LED
will turn on. It means the system is booting up successfully. Furthermore, if you have a proper
network connection, and access to the IP Camera, the LED will flash green under wired mode or
orange under wireless mode.

2.3 Initial Utility Installation

This chapter shows how to quick set up your H.264 camera. The camera is with the default
settings. However to help you find the networked camera quickly the windows utility PLANET IP
Wizard II can search the cameras in the network that shall help you to configure some basic
setting before you started advanced management and monitoring.
1. Insert the bundled CD into the CD-ROM drive to launch the auto-run program. Once
completed, a welcome menu screen will appear.
2. Click the "IP Wizard II" hyperlink; you will see the dialog box as below.
If the welcome screen does not appear, click "Start" at the taskbar. Then, select
NOTE:
"Run" and type "D:\Utility\IPWizard II\setup.exe", assume D is your CD-ROM drive.
3. The "Welcome to the Install Shield Wizard for PLANET IP Wizard II" prompt will display on the
screen and click "Next" to continue.
Full HD PoE/ Wireless Cube IP Camera
17
ICA-1200/W1200