Hardware Installation - Planet Networking & Communication ICA-1200 User Manual

LAN Socket
LAN LED (green color)
Power / Wireless LED
(orange color)
DI/DO Connector

2.2 Hardware Installation

1. Attach the Camera with the included stand
2. Place the Camera on the table or fix it onto ceiling or wall
Use three screws to fix the Network Camera onto the ceiling or wall. You could also put the
Network Camera on the table directly.
device, please follow the steps below:
1. Make sure the Camera is ready first. Insert the paper clip
or other tool and press and hold the button down
continuously.
2. Hold it at least 5 seconds and release the tool while the
Camera is operating. Then the device has been restored
to default settings and reboot again.
Note: Restoring the factory default setting will lose the all
previous settings included IP address forever. User needs to
run the IPWizard II program to search the device and
configure it to let the device work properly again.
The LAN socket is a RJ-45 connector for connections to
10Base-T Ethernet or 100Base-TX Fast Ethernet cabling.
This Ethernet port built N-Way protocol can detect or
negotiate the transmission speed of the network
automatically. Please use Category 5 cable to connect the
Network Camera to a 100Mbps Fast Ethernet network switch
or hub.
This LED is used to indicate whether the camera is ready or
not. In addition, this LED will be flashing while the wireless
accessing of the Camera (WLAN model only).
The Camera has built in a speaker. This speaker allows to
output voice or alerting sound.
The Camera provides a terminal block with 4 pins of
connectors for DI and DO. Please refer to the Appendix A in
this manual for more information. The pin 1 is located at the
left side of terminal block from rear view.
15
Full HD PoE/ Wireless Cube IP Camera
ICA-1200/W1200