Pppoe; Streaming - Planet Networking & Communication ICA-1200 User Manual

3.5.6 PPPoE

PPPoE: Stands for Point to Point Protocol over Ethernet
A standard builds on Ethernet and Point-to-Point network protocol. It allows Internet Camera
connect to Internet with xDSL or cable connection; it can dial up your ISP and get a dynamic IP
address. For more PPPoE and Internet configuration, please consult your ISP.
It can directly connect to the xDSL, however, it should be setup on a LAN environment to program
the PPPoE information first, and then connect to the xDSL modem. Power on again, then the
device will dial on to the ISP connect to the WAN through the xDSL modem.
The procedures are
• Connect to a LAN by DHCP or Fixed IP
• Access the device, enter Setting
PPPoE
User Name
Password
IP Address / Subnet
Mask / Gateway
Status

3.5.7 Streaming

RTSP is a streaming control protocol, and a starting point for negotiating transports such as RTP,
multicast and Unicast, and for negotiating codes. RTSP can be considered a "remote control" for
controlling the media stream delivered by a media server. RTSP servers typically use RTP as the
protocol for the actual transport of audio/video data.
Network
To enable or disable the PPPoE service here.
Type the user name for the PPPoE service which is provided by ISP.
Type the password for the PPPoE service which is provided by ISP.
Shows the IP information got from PPPoE server site.
Shows the Status of PPPoE connection.
47
Full HD PoE/ Wireless Cube IP Camera
PPPoE as below
ICA-1200/W1200