Table of Contents
Advertisement
Cable Connections:
1.
Power Connector: The input power is 12VDC.
Note: Supplies the power to the ICA-312 with the power adapter included in package.
2.
Video Output Connector (BNC port)
The ICA-312 also provides composite video output. User can use BNC video cable to
connect the ICA-312 with a TV monitor or DVR.
3.
RJ-45 LAN Connector: For connect a LAN cable to your Hub/Switch.
The LAN port is a RJ-45 connector for connections to 10Base-T Ethernet or 100Base-TX
Fast Ethernet cabling. This Ethernet port built N-Way protocol can detect or negotiate the
transmission speed of the network automatically. Please use Category 5 "straight" cable to
connect the ICA-312 to a 100Mbps Fast Ethernet network switch or hub.
Note: In case you need to connect the device to PC or notebook directly, you should use a
cross-over cable instead.
2.3 Hardware Installation
1. Fix ICA-312 to the location with wall mount fixture.
2. Plug-in Ethernet Cable into RJ-45 LAN port. Connect an Ethernet cable to the LAN port on the
ICA-312 and connect the other side of the Ethernet cable to a hub/switch.
3. Connect the attached power adapter to camera and plug-in this adapter into power outlet.
4. Connect Video BNC connector to a local TV monitor or DVR if necessary.
5. Done.
2.4 Initial Utility Installation
Insert the bundled CD into the CD-ROM drive to launch the autorun program. Once completed, a
welcome menu screen will appear.
Click the "IPWizard Utility" hyperlink in the welcome screen, the below InstallShield Wizard dialog
box will appear.
Note: If the welcome screen does not appear, click "Start" at the taskbar. Then, select "Run" and
type "D:\Utility\setup.exe", assume D is your CD-ROM drive.
8/57
Advertisement
Table of Contents
