AGFA Rapiline 51 User Manual page 16

MAN START
Press the display will read:
"MANUAL START"
Pressing will start the drive motor,
the circulation pumps, energize valve for
wash water and the dryer (OPERATE mode)
No release of replenisher.
Press again, and the processor will
switch back to READY/IDLE mode.
EXPOSURE PERCENTAGES
Dev. and fix. replenisher quantities are cal-
culated according to the calculation based
on the area of the material (width and length),
the percentage exposure and the basic repl.
quantities (cc/m ) of 50% exposed material
2
according to the information provided by the
manufacturer of film, paper and chemistry.
50% exposure
automatically whenever the processor is
turned on. The replenishment quantity
corresponds to the values stored in the built
in micro-computer. All calculations are based
on 50% exposure. Consequently, the base
of all values displayed is 50% exposure
even when
or
User manual
Page 12/16/GB
mode is selected
are pressed.
DEV
Density
0.3 x calc.
15%
value
Calculated
50%
value
1.7 x calc.
85%
value
REWASH BOX
If you press the key on the rewash box, the
display will read
"REWASH."
Motor, water solenoid and dryer will start up.
No release of replenisher.
CAUTION
To deactivate the rewash function,
press the key on the rewash box
again.
Upon activation of the input sensors, or the
key on the rewash box, the diode in the
rewash box is constantly lit.
FIX
1.7 x calc.
value
Calculated
value
0.3 x calc.
value
18.01.96