AGFA Rapiline 51 User Manual page 13

PROGRAMMING
Each setting has a max. and min. value
which is electronically stored and cannot be
exceeded.
Due to the programming of the micro pro-
cessor the processor will start automatically
in the program it was in when the power was
shut off last time.
The display will indicate
Dev. 35°C 20 s M
Dev. 35°C 20 s A
"Dev. 35°C"= present dev. temp.
"20 s" Present dev. time.
"M"=Manual or "A"= Automatic mode
depending on which mode the processor
was in when last switched off.
MANUAL MODE
The machine is switched on and off manually
on the key
AUTOMATIC MODE
The machine is automatically switched on at
the time programmed in the AUTO start
program and automatically switched OFF at
the time programmed in the AUTO stop
program
18.01.96
or
Programs 1, 2 and 3
Programs 1, 2 and 3 are preprogrammed on
delivery of the processor. Press the relevant
key to switch to the desired program.
HOW TO CHANGE A PROGRAM
Once you have pressed a
and and you press
the figures in the display will increase or
decrease. When reaching the required preset
value, press to store the preset value.
("FUNCTION")
or
User Manual
Page 9/16/GB