Advertisement
Advertisement
Table of Contents
Related Manuals for AGFA ELANTRIX 95 S
Summary of Contents for AGFA ELANTRIX 95 S
- Page 1 User Manual for Agfa User Manual for Agfa :ELANTRIX 95 S / 125 S / 150 S :ELANTRIX 95 S /125 S /150 S Plate Processors Plate Processors User Manual USER MANUAL (GB)
- Page 2 English This manual has been published by LASTRA ATTREZZATURE S.r.l. Via Lombardia, 45 25025 Manerbio (Brescia) – Italy Tel: +39 030 9937059 Fax: +39 030 9938105 Edition 01, January 2005 Part No 01A000001...
-
Page 3: Table Of Contents
English TABLE OF CONTENTS TABLE OF CONTENTS .......... page 3 CONFORMITY STATEMENT........page 4 SAFETY INSTRUCTIONS........page 5 ........page 5 Safety warning symbols GENERAL INFORMATION ........page 6 NAME AND RATING PLATE ........page 7 CHEMICAL PRODUCT HANDLING ....... page 7 OPERATING MODES .......... -
Page 4: Conformity Statement
Tel. +39 030 9937059 – Fax +39 030 9938105 DECLARES UNDER ITS OWN RESPONSIBILITY THAT THE FOLLOWING PRODUCT OFFSET PLATE PROCESSOR Mod. :ELANTRIX 95 S / 125 S / 150 S TO WHICH THIS STATEMENT REFERS, COMPLIES WITH THE REQUIREMENTS OF THE FOLLOWING CEE REGULATIONS: •... -
Page 5: Safety Instructions
English SAFETY INSTRUCTIONS SAFETY PRECAUTION SYMBOLS The person responsible for the operation and The instructions given in this manual upkeep of the equipment must be fully pertaining to safety are highlighted by acquainted with all aspects of its operation and graphic symbols. -
Page 6: General Information
MACHINE DESCRIPTION with a pump that keeps the liquid in circulation and which is also filtered. Plate processors: ELANTRIX 95 S /125 S/ There is a thermostat device, which controls 150 S form part of the latest generation of the temperature in the developer tank. -
Page 7: Name And Rating Plate
English NAME AND RATING PLATE CHEMICAL PRODUCT HANDLING In all communication with the manufacturer The processor requires the use of chemical always refer to the data stated on the name products (developers and gums) which may be and rating plate. dangerous, if handled without due care. -
Page 8: Operating Modes
English OPERATING MODES Reset the plate counter to zero and the drying temperature to 50°C. Refer appropriate plate working PREPARATION FOR USE instructions for the developer temperature, replenishment rates and throughput speed. Ensure that the machine has been installed according to instructions. •... -
Page 9: Processor Programming
English AUTOMATIC REPLENISHMENT: The PROCESSOR PROGRAMMING developer will enter a set amount of liquid for each plate. Press this key to see the set replenisher quantity (ml/m ). It is possible to vary the set data by pressing the + or - key within 3 seconds;... -
Page 10: Regeneration Function
English TIMER: Press this key to set the Use keys + and – to set the values and use automatic switch on/off function of the key L to change line machine. To set an automatic switch on/off time press The machine reads the length of the plate, the TIMER key. -
Page 11: Cleaning And Upkeep
English • close the developer tap. CLEANING AND UPKEEP • re-tighten the filter-holder without the inner cartridge, making sure that the taps on the filters are open, and that the one on the filter-holder is closed. Before beginning maintenance • remove the piping from the replenisher operations, insert the service key drum and insert it into another drum...