Refrigeration; Air Cooled Condensers; Water Cooled Condensers - Cornelius I-SERIES Training Manual

NOTE: A bin thermostat is recommended for dispenser applications. When the bin
thermostat is satisfied, the ice maker will finish the cycle it is in and shut-
down. Part No. bin stat 630000-413
5. R
EFRIGERATION

5.1 Air Cooled Condensers

Air cooled ice machines add heat to the surrounding environment. In some situations
this may over tax the air conditioning system or cause other problems.
Adequate air flow is necessary, including 6 inches (15.2 cm) clearance on the right
side and back.
A louvered front and top panel is available for special applications.
Name 322/522
Top Panel 164874-016
Front Panel 164873-022
A louvered front and top panel is available for special applications.Air cooled ice
machines are not a good choice for industrial applications, or in greasy or dusty envi-
ronments that could lead to plugged condensers.
On some ice machines a condenser filter is available to trap airborne particles.

5.2 Water Cooled Condensers

Water cooled condensers will significantly increase water and sewer costs.
Water cooled condensers require a dedicated water line with 3/8" (.95 cm) i.d. inlet
supplying 20-50 psi (1.4-3.45 BAR) at the ice machine. There should be dedicated
water lines for the ice machine and the condenser. These lines should not be teed off
of one line..
Manual Disconnect Switch
Electrical Service Line
Bin Drain
Tube
© 2001, IMI Cornelius Inc.
330/530
630200-614
164873-019
Shut-Off Valve
Water Filter
Strain Relief
must be used
Dump Valve
Drain Tube
Floor Drain
Bin Drain Tube
I-Series Ice Machine Training Manual
630/830 1030/1230
630200-614 630200-614
164873-020 164873-021
Electrical Service
Line
Manual Disconnect Switch
Shut-Off Valve
Water Filter
Shut-Off Valve
Condenser Water Inlet
Strain Relief
must be used
Dump Valve
Drain Tube
Condenser Water
Drain Tube
Floor Drain
- 9 -