Canon GP160F Service Manual page 407

All in one printer
Hide thumbs Also See for GP160F:
Table of Contents

Advertisement

##0106 [RX] Protocol signal can not be received for 6 seconds in protocol signal standby dur-
ing reception
Cause
• The line condition is poor and the protocol
signal can not be properly received by other
party's machine.
• The line condition is poor and the image
signal can not be properly received by the
other party's machine.
• Malfunction due to echo.
##0107 [RX] Fall back not possible for the transmitting machine during reception
Cause
• The line condition is poor. After a 2400 bit/s
signal is received, the signal from the other
party's machine is not properly received.
• Malfunction due to echo.
##0109 [TX] Signals other than DIS, DTC, FTT, CFR and CRP are received and the limit for
the number of protocol signal re-transmissions is exceeded after DCS output during transmis-
sion
Cause
• Protocol signal abnormality.
COPYRIGHT © 1999 CANON INC.
Download Free Service Manual at http://printer1.blogspot.com
CANON GP160 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 13 TROUBLESHOOTING
Countermeasure
• Have the other party raise the output level
so the protocol signal can be properly
received.
• Raise the modem output level in #2 MENU
parameter 007, so the other party's
machine can properly receive the signal.
(1) Refer to #1 SSSW-SW03 for echo coun-
termeasures
(2) Lower the modem output level in #2
MENU parameter 007, so the transmitted
CFR echo is not received.
Countermeasure
(1) Have the other party's machine's output
level raised so the other party's
machine's signal is properly received.
(2) Adjust the NL equalizer in #2 MENU
parameter 005, so the other party's
machine can properly receive the TCF.
(3) Ease the RTN transmission conditions by
#3 NUMERIC Param. 002-004, so RTN
is not output.
(1) Refer to #1 SSSW-SW03 for echo coun-
termeasures.
(2) Lower the modem output level in #2
MENU parameter 007, so the transmitted
signal's echo is not received.
Countermeasure
• Record the Communication protocol on DAT
and request it to be analyzed by the
Technical Center.
13-173

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gp160dfGp160

Table of Contents