Ignition System Operations; Maintaining The Push Button Ignition System (Q ® 3000); Maintaining The Electronic Ignition System (Q ® 3200); Maintaining The Grill Out ® Handle Light (Q ® 3200) - Weber 3000 Owner's Manual

IGNITION SYSTEM OPERATIONS

The igniter supplies a spark to the igniter electrode
assembly. Whether you are performing routine
maintenance or a troubleshooting check on the ignition
system, read the following to keep your ignition system
working properly.
m WARNING: All gas controls and supply
valves should be in the OFF position.
If the igniter fails to ignite your Q ® barbecue, you will need
to pinpoint where the problem is occurring: with the gas
flow or with the ignition system. Begin by attempting to
match light your burner. Refer to "BURNER IGNITION—
Lighting with a Match." If match lighting is successful, the
problem lies in the ignition system.
MAINTAINING THE PUSH BUTTON
IGNITION SYSTEM (Q 3000)
®
Check that both the white (1) and black (2) ignition
•
wires are attached properly.
• Verify that the igniter button pushes in, clicks and
returns to the out position.
MAINTAINING THE ELECTRONIC
IGNITION SYSTEM (Q 3200)
®
• Verify that the AAA battery (alkaline only) is in good
condition and is installed correctly (3). Some batteries
have a plastic protective wrap around them. This
plastic must be removed before installing battery. Do
not confuse this plastic with the battery label.
• Make sure that both igniter wires are properly attached
to the igniter module. Black wire to black terminal (4),
white wire to white terminal (5).
• Make sure the electronic igniter button is working by
listening for clicking and looking for sparks at burner.
If the electronic ignition system still fails to ignite,
contact the Customer Service Representative in your
area using the contact information on our web site.
Log onto www.weber.com .
®
MAINTAINING THE GRILL OUT
HANDLE LIGHT (Q 3200)
®
• Verify that the three AAA batteries (alkaline only) are
in good condition and are installed correctly. Refer to
"ASSEMBLY."
• Some batteries have a plastic protective wrap around
them. This plastic must be removed before installing
battery. Do not confuse this plastic with the battery
label.
42
WWW.WEBER.COM
®
ROUTINE MAINTENANCE
®
1
2
3
5
4