Error Messages - Fujitsu F-02F Instruction Manual

Screen display turns off when using the fingerprint
sensor.
The terminal goes into sleep mode by pressing the
fingerprint sensor. Slide your finger over the fingerprint
sensor not pressing the sensor.
Fingerprint authentication is unavailable when
connecting terminal with a PC, etc.
When connecting the terminal using a USB cable to a
device which requires grounding such as a desktop PC,
make sure that the device is grounded in advance. If the
connected device is not grounded, fingerprint
authentication may be unavailable. In such a case,
disconnect the terminal from the device and retry
fingerprint authentication.
Data saved in the USB mass storage is not displayed.
Reattach the USB mass storage.
The terminal does not recognize a commercially
available external devices (USB mouse, keyboard, etc.).
When using a commercially available microUSB cable,
connect microUSB cable and external device first, then
connect them to the terminal.

Error messages

Memory space is full
The terminal is low on memory. If you keep using, some
functions and applications may not be operated.
Open setting screen to select unnecessary apps, then
press "Uninstall" to uninstall them.
Displayed when available memory of the terminal is low.
Tap [Setting screen] to delete unnecessary applications.
Alternatively, end running applications or clear cache of
applications to increase memory space. P46, 123
Please wait for a while (Data service)
Packet communication facilities are broken down or line
or packet communication network is very busy. Wait a
while and then operate again.
Cannot activate the fingerprint sensor.
It appears when the fingerprint sensor does not work
properly. If the fingerprint sensor is disabled even if you
turn the power off and on, please contact a docomo Shop
near you.
The PIN unlocking code has been locked
This message appears when PUK code is entered with
docomo mini UIM card is PUK locked. Contact a sales
outlet such as docomo Shop. P126
No SIM card.
Check if the docomo mini UIM card is inserted to the
terminal correctly.
SIM card is locked.
Displayed when you turn on the terminal with PIN code
enabled. Enter the correct PIN code. P126
SIM card error
SIM card removed. Phone will restart.
It may appear when IC of docomo mini UIM card is dirty
or when docomo mini UIM card is removed with the
power ON, but it is not malfunction. Clean the IC of
docomo mini UIM card regularly. Do not remove docomo
mini UIM card with the power ON. The terminal may not
operate normally.
164
Appendix/Index