Avaya 1030 Installation Manual page 14

Hide thumbs Also See for 1030:
Table of Contents

Advertisement

1. Open the battery compartment on the back side of the remote control.
a. Before inserting the batteries, stretch each of the two straps across the outer battery
slot closest to it.
b. Insert the two outer batteries, negative end (-) first against the spring, then press the
positive (+) end into place, trapping the cloth straps beneath the batteries.
c. Lay the longer cloth strap over both batteries and insert the center battery's negative
end against the spring first to trap the longer cloth strap beneath it. Then press the
positive end of the battery into place.
d. Lay the ends of the cloth straps over the center battery and install the cover.
2. To connect the Avaya Video Camera 200, insert the HDMI cable into the HD port on the
rear side of the camera and plug the opposite end into the port marked with the HD in
symbol
on the back of the codec. Insert the power adapter cable into the power
port on the rear side of the camera and plug the power adapter into a power outlet.
3. Insert a video display cable into the port on the rear of your display and the opposite end
into the port marked with the display 1 symbol
the display power cord into a power outlet on the wall.
Note:
If you plan to use external speakers that are not built into the display, connect
the speakers to the port marked with the line out symbol
To connect a second display, insert a video display cable into the port on the rear of your
display and the opposite end into the port marked with the display 2 symbol
back of the codec (3b). Insert the display power cord into a power outlet on the wall. By
default, the second display is blank. After you complete the initial configuration, refer to
"Configuring a Second Display" on page 18 to complete this process.
4. Insert the network cable into the network port marked with the LAN symbol
back of the codec. Insert the opposite end of the network cable into a network port on
the wall.
Avaya 1030 Installation Guide
on the back of the codec (3a). Insert
on the back of the codec.
on the
on the
14

Advertisement

Table of Contents
loading

Table of Contents