Basic Set Up Of The Network - Axis 540 User Manual

Basic Set Up of the Network

Installation Guide
NetWare
UNIX
Windows
OS/2
Macintosh
AXIS 540/640 User's Manual
After connecting the AXIS 540/640 to your network you are now
ready to perform the basic setup procedures. The method of
installation that you choose should be dictated by your printing
requirement and the type of network into which you are integrating.
Proceed with an appropriate installation method from the list below:
• If your Windows platform uses NDPS, follow the instructions in:
- Set Up using NDPS on page 36.
If your Windows platform uses NetWare without NDPS, follow
the instructions in:
- Basic Set Up with AXIS NetPilot™ on page 23. Proceed to:
- Section 4 Setting Up - NetWare
• Perform the basic TCP/IP set up procedures if your network uses
UNIX workstations, as defined in:
- Basic Set Up for TCP/IP on page 26. Refer then to:
- Section 8 Setting Up - UNIX
• If your Windows platform uses NetBIOS/NetBEUI, use the
AXIS NetPilot™ only if you want to change the default print
server name. If this is unnecessary, proceed directly to:
- Section 5 Setting Up - Windows
If your Windows platform uses TCP/IP, you must initially
perform the basic TCP/IP set up procedures, as defined in:
- Basic Set Up for TCP/IP on page 26. Refer then to:
- Section 5 Setting Up - Windows
• If your network uses OS/2 workstations, use the AXIS NetPilot™
only if you want to change the default print server name. If this is
unnecessary, proceed directly to:
- Section 6 Setting Up - OS/2
• If Apple computers are used on your network, you should refer
directly to:
- Section 7 Setting Up - Macintosh
Section 3: Basic Installation
21