Basic Installation; Section 3 Basic Installation; Connecting The Hardware - Axis OfficeBasic USB User Manual

Section 3

Basic Installation

Connecting the Hardware

AXIS OfficeBasic USB
AXIS OfficeBasic
Parallel
AXIS OfficeBasic USB
AXIS OfficeBasic
Parallel
AXIS OfficeBasic USB & AXIS OfficeBasic Parallel User's Manual
LPT1
Connector
Ethernet
connector
Power Adapter
connector
1. Make sure that your printer is switched off and that the Power Adapter is
disconnected from the print server.
2. Locate the serial number, found on the underside label of the print server,
and write it down. You will need this number to configure the print server.
Example: S/N: 00408c181cf0
Connect the printer to the USB port using the USB cable.
Connect the printer directly to the LPT port or using a printer cable.
3. Connect the print server to the network using a twisted pair (category 5 or
better) RJ45 cable, 10baseT or 100baseTX.
4. Switch on the printer and make sure it is ready for use.
5. Connect the Power Adapter to the print server. The Power indicator will light
up. When the Network indicator starts to flash, the print server is correctly
connected to the network.
Test button
Ethernet
Power Adapter
connector
connector
Power
indicator
Parallel
Network
Power
indicator
indicator
Basic Installation
Network
indicator
USB printer port (USB1)
Test button
13