Step 3: Step And Bar Assembly - Cal Spas Gazebos Owner's Manual

Step 3: Step and Bar
Assembly
1. Stand the legs up at 5' apart. Place the upper
step on top of the upper section of the step
(Figure A).
2. To attach the step, screw in 4 screws (2 at
each rear corner): 1 into the step leg and 1
into the step itself (see insert of Figure A).
3. Place the lower step on the lower section of
the step (Figure B).
4. To attach the step,screw in 4 screws (2 on
each on the outside of the step - see insert
in Figure B). Use the toe-in method on both
sides, as shown.
The manufacturer recommends mounting corbels
on the cabinet so that the bar top sits just under
the spa lip.
5. Using 2 1/2" screws, mount the corbels directly
to the cabinet wall (Figure C). Make sure that
the corbels are horizontally level with each
other.
6. Mount the bar top to the corbels with the 2
1/2" screws (Figure C). The screws must be
mounted from the underside of the bar top.
Make sure that the bar top rests just below the
lip of the spa.
2008 Gazebo Owner's Manual
LTR20081011, Rev. A
Northeast Gazebo Assembly
Page 37