Step 2: Anchoring The Main Support Post - Cal Spas Gazebos Owner's Manual

Step 2: Anchoring the Main
Support Post
When scoring the concrete, make sure that the mark
is dark enough to see, as you will be drilling a hole in
the concrete. This hole will be where the anchoring
bolt is located. Also, it is the owner's responsibility to
obtain a 1/2" masonry bit. This bit will be used to drill the
anchoring holes in the foundation. A masonry bit may be
bought at any local hardware store.
Refer to the figure for steps 1 through 3.
1. Pre-drill the anchoring hole using a 1/2" masonry
drill bit. Drill the hole to a depth of no less than 3".
Using a hammer, insert the anchoring bolt by gently
tapping the bolt into place. Continue to tap into
place until the anchoring bolt is seated securely in
the hole.
2. After drilling the hole and inserting the anchoring
bolt, slide the main support post assembly on to the
anchoring bolt and tighten down using the provided
hardware.
3. Repeat these steps for all four corners of the
gazebo.
2008 Gazebo Owner's Manual
LTR20081011, Rev. A
Spa Cabana Gazebo Assembly
Determine spacing of post with spa size
before anchoring into concrete.
Determine spacing of post with spa size
before anchoring into concrete.
4"x 4" Post
4"x 4" Post
Side View
Anchor post into concrete as shown.
Anchor post into concrete as shown.
4"x 4" Post
4"x 4" Post
Front View
2" x 6" Board
2" x 6" Board
Galvanized "L" Bracket
Galvanized "L" Bracket
Anchoring Bolt
Anchoring Bolt
Concrete Foundation
Side View
2" x 6" Board
2" x 6" Board
Anchoring Bolt
Anchoring Bolt
Galvanized "L" Bracket
Galvanized "L" Bracket
Concrete Foundation
Concrete Foundation
Front View
Page 13
Concrete Found