Step 3: Roof Assembly - Cal Spas Gazebos Owner's Manual

Step 3: Roof Assembly

The roof assembly is a relatively easy process. The majority of
the tasks are repetitive. The first part of the roof that needs to be
assembled are the support members. Install the lower support
members first and the upper support members second. The
support members are the 2"x6"x144" (12').
Support Member Assembly
This step requires the help of another person. Use two ladders
when hanging the main support beams.
Tip: Try anchoring the ladders so they don't move while you're on
top of them.
1. With the aid of a ladder, place one 2"x6"x144" roof support
on top of the 2"x6"x90" piece and anchor it to the 4"x4", using
the provided 2 1/2" screws. Make sure that the 2"x6"x144"
is centered between the two 4"x4" main
support posts.
2. Place another 2"x6"x144" roof support on
the opposite side of the 4"x4" main support
post. Screw this piece to the 4"x4" as well.
3. Repeat this process on the other main
support posts that are directly across
from the main support posts that were just
completed.
4. Referring to Figure A, place another
2"x6"x144" roof support on top of the roof
support that was just installed. This next
roof support will in effect create a 90 degree
angle with the other 2"x6"x144" roof support.
Secure the roof support with the provided 2
1/2" screws (Figures B and C).
5. Repeat these steps for the remaining roof
support beams (Figure D).
The 4"x4"x16" post is used to tie the roof grid together
and re-enforce it (shown at right). These posts should
be mounted flush with the bottom of the roof support
beams so they are at the same height as the main
support posts.
2008 Gazebo Owner's Manual
LTR20081011, Rev. A
Spa Cabana Gazebo Assembly
Page 15