Operation / Care Of Your Appliance; Gas Controls Access - Superior SSDVST-CNM-B Care And Operation Instructions Manual

OPERATION AND CARE OF YOUR APPLIANCE
Young children should be carefully supervised when they are in the
same room as the appliance. Toddlers, young children and others
may be susceptible to accidental contact burns. A physical barrier is
recommended if there are at risk individuals in the house. To restrict
access to a fireplace or stove, install an adjustable safety gate to keep
toddlers, young children and other at risk individuals out of the room
and away from hot surfaces.
Les jeunes enfants devraient être surveillés étroitement lorsqu'ils se trou-
vent dans la même pièce que l'appareil. Les tout petits, les jeunes enfants
ou les adultes peuvent subir des brûlures s'ils viennent en contact avec
la surface chaude. Il est recommandé d'installer une barrière physique
si des personnes à risques habitent la maison. Pour empêcher l'accès
à un foyer ou à un poêle, installez une barrière de sécurité; cette mesure
empêchera les tout petits, les jeunes enfants et toute autre personne à
risque d'avoir accès à la pièce et aux surfaces chaudes.
Glass Door is Above
Control Compartment
Latch for
Glass Door
Figure 1
Lift the Lower Control
Compartment Door
up and pull out to
OPENING CONTROL
remove.
COMPARTMENT DOOR
Hook Catch
Control Valve
Out
Up
Lower Control
Compartment Door
Figure 2
WARNING
AVERTISSEMENT
Control Compartment
Access
OFF/PILOT/ON (gas control knob)
HI/LO (flame height
control knob)
Optional OFF/ON
Switch Can be
Installed Here
Piezo Igniter
Gas Controls/Control Compartment
Access
The gas controls can be found behind the control
compartment access door.
NOTE: The top louvered panel and the bottom
louvered control compartment door will remove
and install the same way as follows:
Removing Control Compartment Door:
Open the door by gently lifting it upward until
the hook catches on both sides clear the locating
slots. Then pull door out to remove.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
On millivolt systems, the piezo igniter, HI/LO
flame adjustment knob, and pilot and main gas
OFF/PILOT/ON control knob are located below
the glass panel enclosure. The gas valve for
electronic systems is also located below the
glass enclosure panel. See Figure 1.
Reinstalling Control Compartment Door:
To reinstall, insert the hook catches on each
side of the door into the corresponding slots
in the control compartment opening, then
gently push forward and slide down until it
locks in place.
The standard controls for appliance operation
are located behind the lower louvered control
compartment door located below the appliance
front glass enclosure panel (see Figure 1).
Optional control switches are also available (see
Page 14 - Rocker Switch, Remote Wall Switch,
Remote Control, Unit Mounted Rocker Switch
or Wall Thermostat).
Operation of millivolt and electronic gas con-
trol systems are different. Before lighting and
operating your appliance determine if you have
a millivolt or electronic appliance. Familiarize
yourself with the gas control valve that your
appliance uses. Refer to Figure 2 for access
to the gas control valve.
Millivolt Appliances - Appliances with
Millivolt systems will be fitted with the gas
control valve shown in Figure 3 on Page
Gas Shut-Off
6.
Electronic Appliances - Appliances with
Gas Flex-Line
electronic systems will be fitted with the
electronic valve shown in Figure 4 on Page
Gas Valve
6.
Millivolt Appliances
To light millivolt appliances refer to Figure
1. Detailed lighting instructions are found on
Pages 17 and 18. Millivolt appliance lighting
instructions may also be found on the pull out
lighting instruction labels attached to the gas
control valve.
Once the pilot is lit, the main burner may be
turned ON and OFF using a wall switch, remote
control, optional on unit rocker switch (FRS), or
wall thermostat. To operate: Toggle the switch
between its ON and OFF positions.
If your millivolt appliance is equipped with an
optional remote switch kit (wall switch, remote
control, rocker switch, or wall thermostat) and
the pilot is lit, the appliance main burner may be
turned on and off using the optional switch.
Note: To prevent excessive resistance in burner
circuit (which can cause burner operation
problems), only one burner control switch
should be wired to valve.
5