Table of Contents
Advertisement
RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE
• Hot! Do not touch! The glass and
surfaces of this appliance will be hot
during operation and will retain heat
for a while after shutting off the appli-
ance. Severe burns may result.
• Carefully supervise children in the
same room as appliance.
• If small children are present in the home, it is
recommended that this appliance be fi tted with
a screen door or screen panel kit. See Page 15
for ordering information.
WARNING: IF THE INFORMATION IN THIS MANUAL
IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLO-
SION MAY RESULT CAUSING PROPERTY DAMAGE,
PERSONAL INJURY OR LOSS OF LIFE.
FOR YOUR SAFETY: Do not store or use gasoline
or other fl ammables or liquids in the vicinity of
this or any other appliance.
FOR YOUR SAFETY: What to do if you smell gas:
• DO NOT light any appliance.
• DO NOT touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow your gas suppliers
instructions.
• If your gas supplier cannot be reached, call
the fi re department.
Installation and service must be performed by
a qualifi ed installer, service agency or the gas
supplier.
WARNINGS
OTL Report No. 116-F-29-5
HOMEOWNER'S CARE AND
OPERATION INSTRUCTIONS
DIRECT VENT
SSDV-35/40 SERIES
DIRECT-VENT GAS FIREPLACE HEATERS
P/N 725,033M REV. D 05/2006
MODELS
Millivolt Models
SSDVT-3530CNM
SSDVR-3530CNM
SSDVT-4035CNM
SSDVR-4035CNM
A French manual is available upon request. Order P/N 725,033CF
Ce manuel d'installation est disponible en francais, simplement en
faire la demande. Numéro de la pièce 725,033CF
AVERTISSEMENT: ASSUREZ-VOUS DE BIEN
SUIVRE LES INSTRUCTIONS DONNÉ DANS CETTE
NOTICE POUR RÉDUIRE AU MINIMUM LE RISQUE
D'INCENDIE OU POUR ÉVITER TOUT DOMMAGE
MATÉRIEL, TOUTE BLESSURE OU LA MORT.
POUR VOTRE SÉCURITÉ: Ne pas entreposer ni
utiliser d'essence ni d'autre vapeurs ou liquides
infl ammables dans le voisinage de cet appareil ou
de tout autre appareil.
POUR VOTRE SÉCURITÉ: Que faire si vous sentez
une odeur de gaz:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur. Ne pas vous
servir des téléphones se trouvant dans le bati-
ment où vous vous trouvez.
• Evacuez la piéce, le bâtiment ou la zone.
• Appelez immédiatement votre fournisseur de
gaz depuis un voisin. Suivez les instructions
du fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de
gaz, appelez le service dos incendies.
L'installation et service doit être exécuté par un
qualifi é installeur, agence de service ou le fournis-
seur de gaz.
Electronic Models
SSDVT-3530CNE
SSDVR-3530CNE
SSDVT-4035CNE
SSDVR-4035CNE
Advertisement
Table of Contents
Related Manuals for Superior SSDV-35/40 SERIES
Summary of Contents for Superior SSDV-35/40 SERIES
-
Page 1: Operation Instructions
HOMEOWNER'S CARE AND OPERATION INSTRUCTIONS RETAIN THESE INSTRUCTIONS DIRECT VENT FOR FUTURE REFERENCE SSDV-35/40 SERIES WARNINGS DIRECT-VENT GAS FIREPLACE HEATERS • Hot! Do not touch! The glass and P/N 725,033M REV. D 05/2006 surfaces of this appliance will be hot during operation and will retain heat MODELS for a while after shutting off the appli-... -
Page 2: Safety & Warning Information
SAFETY & WARNIING WARNING WARNING INFORMATION Children and adults should be Do not use these appliances if any part has been under water. alerted to the hazards of high IMPORTANT: PLEASE READ THIS Immediately call a qualifi ed, surface temperatures. Use MANUAL IN ITS ENTIRETY AND professional service technician caution around the appliance... -
Page 3: Table Of Contents
Therefore, it is advisable to have an alternate heat source when installed in a In selecting this SUPERIOR Direct-Vent Gas Appliance you have chosen the fi nest and dwelling. most dependable fi replace to be found anywhere. A beautiful, prestigious, alternative to a wood burning fi... -
Page 4: Gas Controls Access
Gas Pressure - All Models Removing Control Compartment Door: At the time of installation, it must be determined Tables 4, 5 and 6 show the appliances' inlet if the appliance needs to be derated. Contact gas pressure requirements: Open the door by gently liftint it upward until the your local gas supplier for deration requirements hook catches on boths sides clear the locating for your area. -
Page 5: Operation / Care Of Your Appliance
If your millivolt appliance is equipped with an If your electronic appliance is equipped with an 2. During the fi rst initial burns of these appli- optional remote switch kit (wall switch, remote optional remote wall switch or remote control kit ances, there will be some odor emitted (see control or wall thermostat) and the pilot is lit, Burn-In Period on Page 4). -
Page 6: Maintenance
Clean Logs And Burner MAINTENANCE IMPORTANT Carefully remove the logs (use care when han- (See Maintenance Schedule, Page 21) It is imperative that the control dling the fi ber logs, as they become quite fragile Refer to the maintenance schedule for maintenance after curing). -
Page 7: Front Glass Enclosure Panel, Removal And Installation
Removing Glass Enclosure Panels Do not attempt to repaint the appliance until the WARNING (see Figure 6) fi nish is completely cured (see Burn-In Period on Page 4). If the surface later becomes stained The glass door of this appli- or marred, it may be lightly sanded and touched 1. -
Page 8: Install Volcanic Stone
SSDV-4035 - Install as Follows INSTALL VOLCANIC STONE, GLOWING WARNING EMBERS AND LOGS Carefully position the ceramic fi ber logs into the The size and position of the log set fi rebox as shown in Figure 9. Logs should be 1. -
Page 9: Log Placement Instructions
MODEL SSDV-3530 Log Placement Instructions LOG SET Catalog Number H3367 * Item Description Log, Rear Log, Top Left Log, Center Log, Top Right * Item "letters" above correspond to photos Install the Embers, Volcanic Stone and Logs in the order shown here (1 through 5) and per the instructions on Page 8. - Page 10 MODEL SSDV-4035 Log Placement Instructions LOG SET Catalog Number H3368 * Item Description Log, Rear Log, Top Left Log, Center Log, Top Right * Item "letters" above correspond to photos Install the Embers, Volcanic Stone and Logs in the order shown here (1 through 5) and per the instructions on Page 8.
-
Page 11: Burner Flame Adjustments
BURNER ADJUSTMENTS (QUALIFIED TECHNICIANS ONLY) Flame Appearance and Sooting Proper fl ame appearance is a fl ame which is blue at the base and becomes yellowish-orange in the body of the fl ame. When the appliance is fi rst lit, the entire fl ame may be blue and will gradually turn yellowish-orange during the fi... -
Page 12: Millivolt Appliance Checkout
Electronic Appliance Checkout Burner Air Shutter Adjustment SIT MILLIVOLT PILOT ASSEMBLY Proper Pilot Flame Appearance To light the burner, refer to the lighting instruc- Adjustment Setscrew Igniter Rod Hood tions on Pages 19 & 20. Ensure the igniter Adjustment Rod Up lights the pilot. -
Page 13: Wiring Diagrams
WIRING DIAGRAMS Electronic Wiring Diagram (Honeywell) Showing Blower Wiring for Optional FBK-100, FBK-200 & FBK-250 Kits Schematic Representation Only Wiring diagrams are provided here for refer- ence purposes only. This information is also Wall Mounted Blower Speed Control Switch or ON/OFF Switch for Blower Kit (optional) Auxiliary View A provided on schematics attached directly to the... -
Page 14: Accessory Components
ACCESSORY COMPONENTS Product Reference Information Cat. Model Ship. Ship.Vol. Wt.(lbs) (inches) H3325 SSDVT-3530CNM 115 lbs 37W x 17D x 36H (13.1 cu.ft). H3326 SSDVT-3530CNE 115 lbs 37W x 17D x 36H (13.1 cu.ft). H3327 SSDVR-3530CNM 115 lbs 37W x 17D x 36H (13.1 cu.ft). - Page 15 This easy to install optional screen installs over the (ref. Form # 750,166M) standard glass enclosure panel to provide protec- * Superior Nameplate Logo, 56L93, is not included. tion from inadvertant direct contact with the hot glass surface. These screen panels cannot be Polished Brass &...
- Page 16 ACCESSORY COMPONENTS Arch Door Kit - Polished Brass Cat. No. Model Fireplace Model 26M43 ADK35CMPB SSDV-3530 81L35 ADK40CPB SSDV-4035 Arch Door Kit - Brushed Stainless Steel 3 Piece Trim Kit Cat. No. Model Fireplace Model Cat. No. Model No. Description 26M44 ADK35CMBS SSDV-3530...
-
Page 17: Lighting Instructions - Millivolt
LIGHTING INSTRUCTIONS – HONEYWELL AND SIT MILLIVOLT GAS VALVE FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted with a piezo •... - Page 18 INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT HONEYWELL ET SIT POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT : SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A.
-
Page 19: Lighting Instructions - Electronic
LIGHTING INSTRUCTIONS — ELECTRONIC FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. When lighting the appliance, follow these instructions •... - Page 20 INSTRUCTIONS D’ALLUMAGE — ELECTRONIC POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT: SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A.
-
Page 21: Maintenance Schedule
MAINTENANCE SCHEDULE Annually (Before the onset of the Burning Season) MAINTENANCE TASK ACCOMPLISHING PERSON PROCEDURE Inspecting/Cleaning Burner, Logs Qualifi ed Service Technician Inspect valve and ensure it is properly operating. Check piping and Controls for leaks. Vacuum the control compartment, fi replace logs and burner area. -
Page 22: Troubleshooting Guide - Millivolt
TROUBLESHOOTING Note: Before troubleshooting the gas control system, Ensure external gas shut off valve, located at gas supply inlet, (and wall switch, iff applicable), is in the “ON” position. Important: Valve system troubleshooting should only be accomplished by a qualifi ed service technician. TROUBLESHOOTING GUIDE - MILLIVOLT GAS CONTROL SYSTEM SYMPTOM POSSIBLE CAUSES... - Page 23 TROUBLESHOOTING PROCEDURE - ELECTRONIC IGNITION SYSTEM START CHECK • Turn Off Gas Supply. • Check for proper volt- • Line voltage power age at control harness • Ensure Valve Switch Is In ON Position. • Low voltage transformer (see insert A). Voltage •...
-
Page 24: Replacement Parts List
Bag of Decorative Volcanic Stone 80L42 80L42 Gas Line Flexible Connector, FFGC 93L32 93L32 * Superior Nameplate Logo, 56L93, is not included. Gas Controls - Honeywell Millivolt Gas Controls - SIT Millivolt Natural Gas Propane Gas Natural Gas Propane Gas Part No. - Page 25 REPLACEMENT PARTS DIAGRAMS NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
- Page 26 NOTES NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
- Page 27 NOTES NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
- Page 28 LHP reserves the right to make changes at any time, without notice, in design, materials, specifi cations, prices and also to discontinue colors, styles and products. Consult your local distributor for fi replace code information. Printed in U.S.A. © 2005 by LHP P/N 725,033M REV.