Superior SSDVST-CNM-B Care And Operation Instructions Manual page 10

WARNINGS
• This appliance is not designed
to burn wood. Any attempt to
do so could cause irreparable
damage to appliance and prove
hazardous to your safety.
• If logs are not installed accord-
ing to the log installation
instructions, flame impinge-
ment and improper combus-
tion could occur and result in
soot and/or excessive produc-
tion of carbon monoxide (CO),
a colorless, odorless, toxic
gas.
Burner / Grate Location Reference
(see Figures 8 and 9)
Note: If the burners have been removed for any
reason, rear burner must be installed before
front burner. See Figures 8 and 9.
Install the decorative volcanic stone and
glowing embers (rockwool):
Spread the decorative volcanic stone on the
simulated brick floor of the firebox around
the burners to simulate ashes. Maintain a 1/2
inch (13 mm) gap between the bottom of the
horizontal grate section and the top of the pile
of decorative volcanic stone. Place a few quar-
ter-sized pieces of the glowing ember material
on the pan burner in front of the burned out
area on both sides of the log set. The glowing
embers may touch one another, but should not
overlap each other.
Proper Burner Flame Appearance
Figure 7
10
Install the unitized log set:
a. The bottom of the log set is notched to ac-
commodate the pilot.
b. Place the log set so that the four inner
notches on the underside of the log set fit
over the four risers located on the burner
ends. See Figure 7. This procedure is
accomplished primarily by feel, as the log
set masks the burner risers as it is being
installed.
c. As a final check for correct log set placement,
check that the four outer notches on the
underside of the log set fit over the burner
tines as indicated in Figure 7.
Glowing Embers
Separate into Quarter
Size (separate) Pieces
Bag of Glowing
Embers (rockwool)
Figure 6
REFERENCE
Firebox Accessories / Parts
Cat. No. Model No. Description
88L53 FGE Bag of Glowing Embers
Bag of Decorative
80L2 FDVS
Volcanic Stone
Volcanic Stone
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
BURNER POSITIONING
NOTE: INSTALL REAR BURNER FIRST,
THEN FRONT BURNER.
BURNER
BRACKET A
REAR BURNER
FRONT BURNER
Note: The burners are not identical. Position them so
that the circular burner ports run as shown. Note
especially the vertical run of ports relative to the pilot
burner. Bracket A on the rear burner will interfere
with the pilot burner if an attempt is made to install
the rear burner in the front burner's position.
Figure 8
NOTE: INSTALL REAR BURNER FIRST,
THEN FRONT BURNER.
Outer Log
REAR BURNER
Notch Location
Riser - Inner Log
Notch Location
Outer Log
Notch Location
FRONT BURNER
Notch Location
FIREBOX SUBFLOOR
FRONT OF FIREPLACE
LOG NOTCH LOCATION RELATIVE TO BURNER
Figure 9
Unitized Log Set
PORTS
PILOT
BURNER
Outer Log
Notch Location
Riser - Inner Log
Notch Location
Outer Log
Pilot Assembly