Fishman SoloAmp User Manual page 5

Cabling Precautions
When making your cable connections, always be sure to route the cables so that
the audience, performers, or anyone else will not trip over them or accidentally
pull the SoloAmp over.
Setting SoloAmp Controls
1. Plug the provided AC line cord into
the back of the amplifier.
2. Locate the Power switch and switch
it off, then connect the power cord.
3. Plug the SoloAmp into an electrical
outlet with the appropriate AC
voltage.
4. Push in the Mute switch and turn
on the Power switch. You should
see the front panel power LED
glow green.
5. Connect your instrument to the
Channel 1 input with a shielded
1/4-inch cable.
6. Play aggressively and raise the
Channel 1 Gain knob until the Clip
LED flashes, then back off the Gain
until no clipping occurs.
7. Set the controls as shown here.
8. Push the Mute switch (out) and
slowly raise the Master Volume to
the desired level.
5