Page 2
1. Set the controls • Set volume and notch off. Set the bass, middle, treble and brilliance controls to center. 2. Plug in • Connect the Presys Plus to an amplifi er or PA with a ¼-inch instrument cable. The battery light (batt) will fl ash once quickly to indicate it has switched on.
Page 4
Presys Plus Controls Volume • For the cleanest signal, set the volume knob as high as possible, without causing distortion or feedback. Bass • Boost here to add depth and weight to the sound of the guitar. Middle • Turn the middle knob all the way left for a smooth “scooped out”...
Page 5
To conserve power, unplug the instrument and turn off the tuner when not in use. Replace the battery by fl ipping open the preamp body using the latch located above the Fishman logo. Be sure to observe the correct polarity during this installation.
Page 6
Sample EQ Settings Fingerstyle “Scooped” Mid This will add fullness to the bass This setting emphasizes extreme bass and defi nition to the treble. and treble...
Page 7
Strummer Cut Through the Mix A good setting for strumming chords. When you need to be heard through a loud band.
Page 9
PRESYS PREAMP CUT-OUT TEMPLATE www.fishman.com 2.00 NOTE: When using mounting brackets, 50.80 screw holes should be .093” [2.38mm] .852 21.82 2.662 2.573 2.795 67.62 65.35 71.00 1.785 .288 45.34 R 7.32 www.fishman.com 513-200-138_r2...
Page 10
PRESYS PREAMP INSTALLATION GUIDE fishman.com Step 3: Preamp Location Step 4: Attach Preamp Step 1: Endpin Jack Step 2: Sonicore Pickup Installation Installation Widen the endpin hole to ” Drill a ” hole (2.4mm) in the Position the preamp on the flat- Attach the preamp to the guitar (11.9mm) to accomodate the saddle slot for the pickup wire,...