JVC GR-DVP7 Instructions Manual page 61

To make video clips from recorded video
footage
Stop Button (8)
VIDEO/MEMORY Switch
SNAPSHOT Button
E-MAIL Button
1
Load a cassette. (
2
Load a memory card. (
3
Set the VIDEO/MEMORY Switch to "VIDEO".
4
Set the Power Switch to "P" while pressing
down the Lock Button located on the switch.
5
Set "E-CLIP REC" to the desired image size.
( pg. 38, 60)
6
Press 4/9 to start video playback.
7
Press E-MAIL to engage the E-Mail Clip Record-
Standby mode.
"E-MAIL CLIP STANDBY"and "PUSH
"SNAPSHOT" TO RECORD CLIP TO CARD"
appears.
To cancel E-Mail Clip Recording, press E-MAIL
again or press 8 to stop video playback.
8
At the point you want to start dubbing, press
SNAPSHOT to start E-Mail Clip Recording.
9
Press SNAPSHOT to stop E-Mail Clip Recording.
"COMPLETED" is displayed, then the
camcorder re-enters the E-Mail Clip Record-
Standby mode.
10
Press E-MAIL to end E-Mail Clip Recording.
The normal screen reappears.
Play/Pause
Button (4/9)
Power Switch
Lock Button
pg. 16)
pg. 17)
To view video clips stored in a memory card...
Refer to "Playback Of Video Clips" (
To delete unwanted video clips stored in a memory
card...
Refer to "Deleting Files" (
NOTES:
Playback operation cannot be performed during
E-Mail Clip Recording.
If the end of the tape is reached during E-Mail Clip
Recording, that portion will be automatically
stored in the memory card.
If the end of the tape is reached in step 7, the
E-Mail Clip Record-Standby mode will be
automatically cancelled.
The video clip files stored with this camcorder are
compatible with MPEG4. Some MPEG4 files
stored with other devices cannot be played back
with this camcorder.
Video noise may appear while viewing video clips
in the LCD monitor or viewfinder, however, this
noise is not present in the actual video clips stored
in the memory card.
You can also view video clips on your PC by using
®
Windows Media Player version 6.4 or later. Refer
to the instructions of PC and software.
61
EN
pg. 29).
pg. 33).