JVC GR-DVP7 Instructions Manual page 11

Using The Battery Pack
A
Notches
B
1
Align the battery pack's two notches with the tabs
on the camcorder's battery pack mount.
2
Insert the terminal end 1 of the battery pack into
the battery pack mount.
3
Firmly push the end 2 of the battery pack until it
locks into place.
To detach the battery pack...
While sliding down BATT. RELEASE, remove it.
NOTE:
When using the battery pack and the S/AV/Editing
cable, disconnect the S/AV/Editing cable first
( pg. 25), and then detach the battery pack.
Approximate recording time
Battery pack LCD monitor on Viewfinder on
BN-V107U 1 hr.
BN-V114U
2 hr.
(optional)
BN-V840U
5 hr. 10 min.
(optional)
BN-V856U
7 hr. 40 min.
(optional)
NOTES:
Recording time is reduced significantly under the
following conditions:
• Zoom or Record-Standby mode is engaged
repeatedly.
• The LCD monitor is used repeatedly.
• The playback mode is engaged repeatedly.
Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned shooting time.
ATTENTION:
Before detaching the power source, make sure
that the camcorder's power is turned off. Failure to
do so can result in a camcorder malfunction.
INFORMATION:
The optional extended-use battery pack kit is a set
composed of a battery pack and AC Power Adapter/
Charger:
VU-V840 KIT: BN-V840U battery pack & AA-
VU-V856 KIT: BN-V856U battery pack & AA-
Read the kit's instruction manual before using.
Also, by using the optional JVC VC-VBN856U DC
BATT. RELEASE
Cord, it will be possible to connect BN-V840U or
Switch
BN-V856U battery packs to the camcorder and
supply power directly to the camcorder.
Using AC Power
1 hr. 10 min.
2 hr. 20 min.
6 hr.
1
9 hr. 10 min.
2
3
4
NOTES:
V15EG or AA-V15EK AC Power
Adapter/Charger
V80EG or AA-V80EK AC Power
Adapter/Charger
To AC outlet
AC Power Adapter/
Charger
POWER indicator
(red)
To battery pack mount
Make sure you unplug the camcorder's DC cord
from the AC Power Adapter/Charger.
Plug the AC Power Adapter/Charger's power cord
into an AC outlet. The POWER indicator lights.
Attach the coupler part of the DC cord to the
camcorder's battery pack mount.
Plug the DC cord to the DC OUT connector on
the AC Power Adapter/Charger.
The provided AC Power Adapter/Charger features
automatic voltage selection in the AC range from
110 V to 240 V.
For other notes, pg. 81.
11
EN
Power cord
To DC OUT
connector
DC cord