Section 6 Recycling Vue ™ Pack's Plastic Cup; Section 7 Troubleshooting - Keurig Vue V1200 Use & Care Manual

SECTION 6
Recycling Vue Pack's Plastic Cup
™
Recycle your Vue
plastic is accepted. #5 plastic may not be recyclable in
your community today, so please check locally with
your municipality or waste hauler, or visit
www.vuerecycling.com for more information about
recycling your Vue
Simply follow these simple steps:
Step 1
Once brewing is complete, lift the Brewer Handle and
carefully remove the Vue
Step 2
Once cool, separate the lid and filter from the cup.
The filter will adhere to the lid.
Step 3
Once separated, discard the lid and the attached filter.
Recycle your Vue
plastic is accepted.
22
pack's plastic cup wherever #5
™
pack's plastic cup.
™
pack by holding the outer rim.
™
The Vue pack will be HOT after brewing. Use
™
caution when removing. Allow it to cool completely
before handling.
pack's plastic cup wherever #5
™
SITUATION SOLUTION
Brewer does not • Make sure that the Power Button has been turned on and
have power Touchscreen is illuminated.
• Plug Brewer into an independent outlet.
• Check to be sure that it is plugged in securely.
• Plug into a different outlet.
• Reset the circuit breaker if necessary.
Brewer will • After placing the Vue
not brew sure the Handle is pushed down securely and the Touchscreen
displays the beverage options. Push the flashing "BREW"
Button.
• If the Touchscreen indicates "Please Add Water," add water to
the Water Reservoir or make sure the Water Reservoir is seated
properly in its base.
• If the Touchscreen indicates "Please Add Water" even after
refilling, contact Customer Service at 1.888.CUP.BREW (287.2739).
• The Brew Head may need to be cleaned or the Brewer may need
to be de-scaled (refer to pages 20 and 21).
Brewer brews only • Clean the Brew Head if necessary (refer to page 20).
a partial cup • The Water Reservoir may have been removed during brewing.
Replace the Water Reservoir and perform cleansing brews
(refer to page 15) without a Vue
• De-scale the Brewer (refer to page 21).
• If you have repeated the de-scale procedure on your Brewer
two times and it is still only brewing a partial cup, contact
Customer Service at 1.888.CUP.BREW (287.2739).
Brewer shuts • Check to make sure that the "On/Off Time" and/or "Auto Off"
off or turns on settings have not been set. Please refer to pages 17 and 18 for
automatically instructions.
Water Reservoir • The water level is low and a full cup cannot be brewed.
light is flashing and Add water to Water Reservoir.
the Touchscreen indicates • If the water level is not low, remove the Water Reservoir and
"Add Water" empty the water. Then thoroughly clean (refer to page 20). Fill
the Water Reservoir to the "MAX FILL" line and then return it to
the Brewer and ensure it is seated properly in its base. Wait for
the Water Reservoir light to stop flashing.
Vue pack does • Please refer to pages 24-27
™
not have MyBrew
™
The Time is not displayed • If power is interrupted to the Brewer by unplugging it, or if
on the Touchscreen power is lost, follow the procedure on page 17 to set the clock.
SECTION 7
Troubleshooting
pack in the Vue pack Holder, make
™ ™
pack.
™
23