Lan - Vivotek NR8201 User Manual

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

LAN

This page allows user to configure LAN configuration for the Network Video Recorder. It
contains two columns: "LAN" and "DHCP Server."
LAN / DHCP Server
This page allows Administrators to configure network connection in LAN for the Network Video
Recorder. It contains two columns: "LAN" and "DHCP Server." In LAN, the default IP Address for
the Network Video Recorder is 192.168.100.1. The default Subnet Mask is 255.255.255.0.
If you set up the network video recorder in LAN and link its LAN Port to network cameras
and computer as the picture shows below, the DHCP server of network video recorder will
automatically assign IP address to the linked devices. (192.168.100.2 ~ 192.168.100.254)
IP address: 192.168.100.4
Subnet mask: 255.255.255.0
IP address: 192.168.100.3
Subnet mask: 255.255.255.0
NOTE
► In order to comply with IEC 60950-1 regulations, DO NOT connect the LAN ports to other devices
(such as a PC). These LAN ports are designed for camera connections, and come with PoE power
through the lines, which may impose unpredicted problems when connected to a non-PoE device.
Although PoE detection circuits have been implemented with these ports, it is best to avoid the
connections to devices other than cameras.
►The LAN ports should be connected only to PoE networks without routing to the outside plants.
►The starting and ending address of the DHCP server must be in the same subnet as the IP address of
the LAN interface of the NR8201/8301.
24 - User's Manual
RESET
LAN
IP address: 192.168.100.5
Subnet mask: 255.255.255.0
IP address: 192.168.100.6
Subnet mask: 255.255.255.0
LAN4 LAN3 LAN2 LAN1 WAN
1 2 3 4 5 6 7 8 9 10 11 12
LAN/WAN
IP address: 192.168.100.2
Subnet mask: 255.255.255.0
IP address: 192.168.100.1
Subnet mask: 255.255.255.0
NR8201